Strukturovaná kabeláž a kabeláž pro datová centra
Metz, DRIW-E16, 230 V AC
| Kód: | 1101500522 |
- The speed and V-belt monitor is used for monitoring the rotary movement (insufficient speed) of motor and V-belt driven shafts
- Inductive proximity switches are used for capturing the speed
- Pulses are generated by the sensor without contact by means of driven control cams, toothed wheels, segmented discs, metal signal flags or similar
| Cena: | dostupná po přihlášení | ||
| Dostupnost: | Brno |
Praha |
na vyžádání |
| Množství: | ks |
|
|
- The speed and V-belt monitor is used for monitoring the rotary movement (insufficient speed) of motor and V-belt driven shafts
- Inductive proximity switches are used for capturing the speed
- Pulses are generated by the sensor without contact by means of driven control cams, toothed wheels, segmented discs, metal signal flags or similar
- The relay is activated when the operating voltage is applied
- After start-up bridging has finished, the monitoring function is started on the E1 and E2 terminals by means of the power contactor of the drive
- When the drive speed falls below the switch-off speed, the relay is deactivated
- The fault message of the speed or V-belt monitor is reset by means of the reset function and by switching off the operating voltage
Technická specifikace
| Operating voltage | 230 V AC |
| Recovery time | 400 ms |
| Type of monitoring | Low speed |
| Max. monitoring range | 4200 pulses/min |
| Switch-off range | 120 pulses/min |
| Sensor input | Two-wire |
| Start-up bridging | 60 s |
| Outputs | 2 changeover contacts (DPDT) |
| Output / switching voltage | 250 V |
| Output / current | 6 A |
| Output / total current | 8 A / across all contacts |
| Display | Green and red LED |
| Dimensions (W x H x D) | 22.5 x 61.3 x 60 mm |
| Weight | 70 g |
| Operating temperature range | 0 °C to +55 °C |
| Storage temperature range | -20 °C to +70 °C |
| Ingress protection for housing / terminal block | IP40 / IP20 |
Originální text
The speed and V-belt monitor is used for monitoring the rotary movement (insufficient speed) of motor and V-belt driven shafts. Inductive proximity switches are used for capturing the speed. Pulses are generated by the sensor without contact by means of driven control cams, toothed wheels, segmented discs, metal signal flags or similar. The relay is activated when the operating voltage is applied. After start-up bridging has finished, the monitoring function is started on the E1 and E2 terminals by means of the power contactor of the drive. When the drive speed falls below the switch-off speed, the relay is deactivated. The fault message of the speed or V-belt monitor is reset by means of the reset function and by switching off the operating voltage.